Hangzhou Fenglei Industrial Co., Ltd.
Main products:Siliconesealant, Anaerobic adhesive, AB adhesive, Gasket maker
Products
Contact Us
  • Contact Person : Mr. Wang Bentley
  • Company Name : Hangzhou Fenglei Industrial Co., Ltd.
  • Tel : 86-571-82452935
  • Fax : 86-571-82452937
  • Address : Zhejiang,Hangzhou City,Yuelian Industrial Park,Jinhua Town,Xiaoshan District
  • Country/Region : China
  • Zip : 311253

Silicone Gasket Maker

Silicone Gasket Maker
Product Detailed
Improved oil resistance Good adhesion and flexibility Replaces most cut gaskets Non-flammable, Non-toxic Low Odor

 PRODUCT DESCRIPTION         

Acetic RTV Silicone Adhesive Gasket Maker is a  single component, room temperature vulcanizing (RTV) gasketing compound, designed for the sealing of mechanical assemblies. Upon curing from the exposure to moisture in the air, this non-sagging paste forms a tough, flexible, waterproof seal of silicone rubber, which resists aging, weathering and thermal cycling without hardening, shrinking or cracking.  Conforms to MIL-A-46106B, Type I.   Acetic  RTV Silicone Adhesive Sealant shall meet the requirements of the F.D.A. Code of Federal Regulations 21 CFR concerning food contact applications if used in accordance with its Section 177.2600: Rubber Articles Intended for Repeated Use.  PRODUCT BENEFITS   Easy application   Applied to horizontal or vertical surfaces   Superior adhesion and flexibility   Waterproofs   Insulates   Unaffected by vibration   Non-flammable 

TYPICAL APPLICATIONS Acetic Silicone Gasket Maker is an excellent all-purpose adhesive/sealant for the following materials: Metal Glass 

Wood Plastic Silicone resin Vulcanized silicone rubber Ceramics Natural and synthetic fibers 

 Painted surfaces 

DIRECTIONS FOR USE For Assembly 1.  Remove all previous material from mating surfaces.  JIYUAN Gasket Remover  is recommended for most  materials, not  for plastics or painted surfaces. 2.  For best results, clean and dry all surfaces with a residue-free solvent, such as JIYUAN Brake and Parts Cleaner. 3.  Cut nozzle to desired bead size, 1/16 to 1/4 in diameter.  An 1/8 bead is usually sufficient for most applications. 4.  Remove cap, puncture tube or cartridge seal and attach extension nozzle. 5.  Apply a continuous and even bead of silicone to one surface, as shown below: 6.  Assemble parts immediately while silicone is still wet.  Secure or tighten as required, avoiding excessive squeeze-out. 7.  Re-torque will not be necessary after the product has cured.

Silicone Gasket Maker



Copyright Notice @ 2008-2012 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.